Avaya Configuring Differentiated Services Manual de usuario Pagina 78

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 86
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 77
Configuring Differentiated Services
B-4
308620-14.00 Rev 00
7.
After all the data is sent, the BLN router waits for 2 minutes, which in this
example is the idle time, and then removes the flow filter. It then sends a
message to the bandwidth broker indicating that the flow filter has been
removed.
Configuring the Router
The router’s configuration for the differentiated services network in Figure B-1 is
shown in the following sections.
These tables provide instructions on how to access the appropriate Site Manager
windows and configure specific parameters. Only those parameters that you must
change from the default value are listed. If a parameter is not included, it means
that you can accept the default value.
Configure a Differentiated Services Interface
First, configure a differentiated services interface and enable COPS, as follows:
Site Manager Procedure
You do this System responds
1. In the Configuration Manager window,
click on an IP interface connector.
The Add Circuit window opens.
2. Accept the default circuit name or enter a
new name, then click on
OK
.
The Select Protocols window opens.
3. Scroll through the list of protocols and
choose
DiffServ
, then click on
OK
.
The IP Configuration window opens.
4. Enter
192.32.46.9
in the
IP Address
parameter, then click on
OK
.
The DiffServ Interface List window opens.
The interface is now enabled.
5. Set the
Config Type
parameter to
COPS
. Site Manager displays a message
informing you that the static filters will be
deleted and asks if you want to continue.
6. Click on
OK
. You return to the DiffServ Interface List
window.
7. Click on
Done
. You return to the Configuration Manager
window.
Vista de pagina 77
1 2 ... 73 74 75 76 77 78 79 80 81 82 83 84 85 86

Comentarios a estos manuales

Sin comentarios