Avaya Configuring SDLC Services Manual de usuario Pagina 60

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 74
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 59
Configuring SDLC Services
4-22 114053 Rev. A
Parameter: RNR Retry Limit
Default: 4
Range: 1 through 64000
Function: Used with the RNR Timer parameter to provide the overall timeout before
sending an outage message to a device.
Instructions: Enter a value from 1 through 64000, where 1 causes SDLC to generate an
outage after the first RNR Timer expires, and 64000 specifies an infinite
number of retries.
MIB Object ID: 1.3.6.1.4.1.18.3.5.1.7.5.1.27
Parameter: REPLYTO Timer
Default: 30 tenths of a second
Range: 1 through 600
Function: Specifies the maximum length of time a primary link station waits for a
response frame (after sending a frame with a poll bit) before trying to poll
another station. This timer starts when a frame without the F-bit is
received, and stops only when a frame with an F-bit is received.
Instructions: Enter a value from one tenth of a second through 600 tenths of a second.
You should set the timeout value to be no less than the result of the
following formula:
(2 + MAXOUT) x (MAXDATA x 8) x 10
÷ line speed in bits/sec
Edit the REPLYTO Timer value whenever you adjust baud rate with the
Internal Clock Speed parameter or the external modem baud rate. For
example, if you are using a line with a 4800 baud rate, increase the
REPLYTO Timer parameter to 60 tenths of a second.
MIB Object ID: 1.3.6.1.4.1.18.3.5.1.7.5.1.8
Vista de pagina 59
1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 73 74

Comentarios a estos manuales

Sin comentarios