Avaya Configuring PPP Services Manual de usuario Pagina 68

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 118
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 67
Configuring PPP Services
3-16 114068 Rev. A
Specifying PAP Parameters for the Remote Peer
If the remote peer does not have PAP enabled, ignore the remote PAP parameters
that follow.
During the authentication phase of link creation, PPP uses the remote PAP ID and
remote password to verify the local peer’s right to communicate with the remote
router. During the authentication phase, this interface must include the correct
remote PAP ID and remote PAP password in all Password Authenticate-Request
messages it sends to the local peer router; otherwise, the peer router sends an
Authenticate-NAK message and the link is not created.
If the remote peer has PAP enabled, specify the Remote PAP ID parameter, which
assigns a PAP identifier to the remote peer. There is no default value.
Now set the remote PAP password.
The Remote PAP Password parameter specifies the password assigned to the
remote peer router. The password can consist of any text string, up to 25
characters long. There is no default value.
Allowing PAP Rejection
Some peers do not use PAP. If you set the Allow PAP Reject parameter to Enable,
your router accepts the Reject message from such a peer and removes PAP from
the LCP Configure-Request.
The default value is Disable.
Site Manager: Remote PAP ID parameter: page A-19
Site Manager: Remote PAP Password parameter: page A-19
Site Manager: Allow PAP Reject parameter: page A-24
Vista de pagina 67
1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 117 118

Comentarios a estos manuales

Sin comentarios