
Configuring Ethernet, FDDI, and Token Ring Services
A-14 117020-A Rev. A
Parameter: MAC Address Select
Path: Configuration Manager > TOKEN Connector > Edit Line > Edit Token Ring
Parameters
Default: PROM
Options: BOXWIDE
| PROM | CNFG
Function: Determines the source of the MAC address.
Instructions: Enter BOXWIDE if you want the token ring interface to use a MAC address that
the software generates from the router’s serial number.
Enter PROM if you want the token ring interface to use a MAC address from
programmable read-only memory on the Token Ring link module.
Enter CNFG if you explicitly assigned a MAC address with the MAC Address
Override parameter.
MIB Object ID: 1.3.6.1.4.1.18.3.4.2.1.10
Parameter: Speed
Path: Configuration Manager > TOKEN Connector > Edit Line > Edit Token Ring
Parameters
Default: 16 Mb/s
Options: 16 Mb/s
| 4 Mb/s
Function: Specifies the speed of the token ring media. If you select 16 Mb/s, the router
enables the Early Token Release protocol, which is used extensively on 16-Mb/s
media. In the unlikely event that you want to disable Early Token Release over
16-Mb/s token ring media, you can do so with the Early Token Release
parameter.
Instructions: Enter the ring speed.
MIB Object ID: 1.3.6.1.4.1.18.3.4.2.1.11
Comentarios a estos manuales