
117020-A Rev. A
xiii
About This Guide
If you are responsible for configuring and managing Bay Networks
®
routers, read
this guide to learn about physical layer (line) configuration procedures.
Before You Begin
Before using this guide, you must complete the following procedures:
1.
Install the router (refer to the installation manual that came with your router).
2.
Connect the router to the network and create a pilot configuration file (refer to
Quick-Starting Routers
,
Configuring Remote Access
, or
Connecting ASN
Routers to a Network)
.
3.
Add the appropriate LAN circuits for the router’s hardware modules (refer to
Configuring Routers
).
4.
Make sure that you are running the latest version of Bay Networks Site
Manager and router software. For instructions, refer to
Upgrading Routers
from Version 7–10.xx to Version 11.0
.
If you want to Go to
Access the line services that you can configure with Site Manager. Chapter 1
Change default settings for Ethernet line services. Chapter 2
Change default settings for FDDI line services. Chapter 3
Change default settings for token ring line services. Chapter 4
Obtain information about Site Manager parameters (this is the same
information you obtain using Site Manager online Help).
Appendix A
View line parameter defaults. Appendix B
See a glossary of terms used in this guide. Glossary
Comentarios a estos manuales