
114048 Rev. A
xiii
About This Guide
If you are responsible for configuring Bay Networks router software for
AppleTalk services, refer to this guide for
• A brief look at the AppleTalk routing protocol in relation to Bay Networks
routing services (see Chapter 1, “AppleT
alk Overview”)
• Implementation notes to help you configure AppleTalk routing services (see
Chapter 2, “AppleT
alk Implementation Notes”)
• Instructions on initially configuring an AppleTalk interface (see Chapter 3,
“Enabling
AppleTalk Services”)
• Instructions on editing AppleTalk global and interface parameters and
configuring AppleTalk services (see Chapter 4, “Editing
AppleTalk
Parameters”)
For information and instructions about the following tasks, see
Configuring
Routers
:
• Retrieving a configuration file
• Rebooting the router with a configuration file
Before You Begin
Before using this guide, you must complete the following procedures. For a new
router:
• Install the router (refer to the installation manual that came with your router).
• Connect the router to the network and create a pilot configuration file (refer to
Quick-Starting Routers and BNX Platforms
,
Connecting BayStack AN and
ANH Systems to a Network
, or
Connecting ASN Routers and BNX Platforms
to a Network)
.
Comentarios a estos manuales