Avaya Bell Canada SIP Trunking Service with Business Communication Manager 450 Nota de aplicación descargar pdf (Pagina 34)

TD; Reviewed:

SPOC 3/15/2013

Solution & Interoperability Test Lab Application Notes

34 of 45

BCSIPTrkBCM

To set the Pub. OLI for a DN, refer to Section 5.5.8. The following screenshot shows the

Application DN range 22392-22399 with the Pub. OLI was set to 416XXX1399.

5.5.10. Administer Incoming Call - Target Lines

For incoming calls, BCM450 uses Target Lines to terminate the calls that match the configured

Pub. Received numbers. The Target Line is assigned as a key on the phone. The maximum

available Target Line is ruled by the system license.

To add a Target Line to a a phone, select Configuration  Telephony  Sets  Active Sets.

Under the Line Access tab, select an active DN e.g. 22264 then go to the Line Assignment, and

click Add (not shown). In the Add Line Assignment dialog, enter the available Target Line e.g.

964.

The sample configuration shows active DN 22264 was configured with Target Line 964 to

receive incoming call to DID number 416XXX1398. It is shown in the screenshot below.

Target Line: 964.

Appearance Type: Appr&Ring. This allows the Target Line to display as a key on the

phone and it will ring per incoming call that matches the configured Priv. Received # or

Pub. Received #.

Appearance: 1. The Target Line will be displayed as 1 particular key on the phone.

Increase the Apparance if more than 1 key are needed.

Caller IP Set: Checked. This enables the Calling Party Name and Number to display on

the phone.

Vmsg Set: Checked if the phone has voice mail enabled on the integrated CallPilot,

otherwise leave this option as unchecked.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 44 45

Sin comentarios

Avaya Bell Canada SIP Trunking Service with Business Communication Manager 450 Nota de aplicación Pagina 34