
Installing IP500/IP500 V2 Page 95
15-601042 Issue 28g (11 October 2013)IP Office 9.0
IP500 V2 Installation: Starting the System
4.11.1 Checking the LEDs
Control Unit LEDs
· Off = Card shutdown.
· Green on = Card present.
· Green flashing = Card in use.
· Orange steady = Reset imminent.
· Red flashing = Card initializing or
shutting down.
· Red fast flashing = card full
· Red steady = Card failure/wrong type.
· Alternate red/green = Starting up.
· Green on = Okay.
· Red on = No software.
· Flashing Red = Error/Shutdown.
Base Card LEDs
· LED1 is also used for base card status:
· Red On = Error
· Red Slow Flash = Initializing.
· Red Flash every 5 seconds = Card
okay.
· Red Fast Flash = System shutdown.
· No status LEDs are used for analog phone extensions.
· Green Flashing = Phone detected.
· Green On = Phone active.
· Green On = Phone detected.
· LEDs 1 to 6
· Green Flashing = Phone detected.
· Green On = Phone active.
· LEDs 1 to 8 are unlabelled. They are used to indicate voice compression channel usage.
Each LED lit represents 12.5% of the available voice compression channel capacity in
use (total card capacity rather than licensed capacity).
· LEDs 1 to 8 are used for the expansion ports on the rear of the control unit. LEDs 9 to
12 are used for the card's own expansion ports.
Expansion module present.
Trunk Daughter Card LEDs
· LED 9 is also used for daughter card status.
· Red On = Error
· Red Slow Flash = Initializing.
· Red Flash every 5 seconds = Card okay.
· Red Fast Flash = System shutdown.
· Green on = V1: Card installed. V2: Line connected to the port but idle.
· Green flashing = Line in use.
· Off = No trunk present.
· Green on = Trunk present.
· Green flashing = Trunk in use.
· Red/Green Fast Flash (port 9) or Green Fast Flash (port 10) = Alarm indication
signal (AIS) from the trunk remote end.
· Red with Green Blink (port 9) or Green Blink (port 10) = Port in loopback mode
(set through IP Office System Monitor).
· Off = No trunk present.
· Green on = Trunk present.
· Green flashing = Trunk in use.
Comentarios a estos manuales