Avaya IP500 V2 Instrucciones de operaciones descargar pdf (Pagina 200)

Installing IP500/IP500 V2 Page 200

15-601042 Issue 28g (11 October 2013)IP Office 9.0

9.9 Receiving the Configuration

The process here applies to systems running IP Office 3.2 and higher.

Objective - Receive a configuration from an IP Office running IP Office 3.2 or higher

software.

Information Required

· o Service User Name and Password

The defaults for full configuration access are Administrator and Administrator.

However these should have been changed as part of the installation process, see

Configuring Security Settings.

Procedure: Receiving the Configuration

1.Select Start | Programs | IP Office | Manager.

2.Click in the main toolbar or select File | Open Configuration from the menu bar.

3.The Select IP Office window appears. After a few seconds it should list the control unit that is being setup. The

default name used is the control units MAC address.

· If the system required was not found, the address used for the search can be changed. Enter or select the

required address in the Unit/Broadcast Address field and then click Refresh to perform a new search.

4.Click the check the box next to the system and then click OK.

5.The name and password request is displayed. The name and password must match one of those setup through the

security settings. The default name and password for full configuration settings access is Administrator and

Administrator.

6.Successful receiving of the configuration is shown by the full configuration tree being shown in the left-hand panel.

With no configuration loaded the navigation pane shows just BOOTP and Operator entries.

IP Office Default Settings

The following are the basic default configuration settings for an IP Office system.

Network Settings

LAN Port (LAN1)

WAN Port

(LAN2)

IP address

192.168.42.1.

192.168.43.1

IP Mask

255.255.255.0

DHCP Mode

Client

No of DHCP IP Addresses

200.

Extensions and Users

A user is automatically created for each physical extension port detected in the system. Users are assigned extension

numbers starting from 201. User names take the form Extn201, Extn202, ....

· Hunt Group

A single hunt group 200 called Main is created and the first 10 users are placed into that hunt group as members.

· Incoming Call Routes

Two default incoming call routes are created. Voice calls are routed to the hunt group Main. Data calls are routed

to the RAS user DialIn.

1 2 ... 195 196 197 198 199 200 201 202 203 204 205 ... 441 442

Comentarios a estos manuales

Sin comentarios

Avaya IP500 V2 Instrucciones de operaciones Pagina 200

Comentarios a estos manuales

Relacionado con productos y manuales para Gateways / Controladores Avaya IP500 V2