Avaya BST Doorphone Guía de configuración descargar pdf (Pagina 14)

14 Chapter 3 BST Doorphone Installation

P1013654 01

For a flush mount:

(into an electrical box embedded in the wall)

• Discard the surface mount gasket and

bracket.

• Slide the flush mount gasket onto the main

housing assembly.

3 Run a standard 3-pair cable from the Business

Communications Manager system to the BST

Doorphone location.

Use one pair to connect the ''KSU'' terminals

of the BST Doorphone to a reserved station

module port on the Business

Communications Manager system.

Strip wires 6 mm (1/4 inch) before inserting

them in the terminal block and tightening.

The second pair can be used to connect an

optional DOC, leaving a spare pair for a

SAPS installation. For more information on

DOC, refer to

Optional Equipment on page 15.

4 Fasten the BST Doorphone’s faceplate to the main housing assembly.

Note: When the surface mount bracket is used, secure the wiring with a cable tie through the

round holes in the rear of the surface mount bracket or electrical box (customer supplied),

before fastening the BST Doorphone’s faceplate to the main housing assembly.

Flush mount

gasket

Main housing

assembly

Faceplate

Wall

Figure 12 Flush mount

KSU SAPS DOC

Note: BST Doorphone connections

are polarity insensitive.

Figure 13 BST Doorphone TCM connector

screw block

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Sin comentarios

Avaya BST Doorphone Guía de configuración Pagina 14