
Getting Started
117353-A Rev. A 1-19
Configuring Circuits
To configure dial-up circuits, refer to the appropriate section for instructions:
• “Creating Demand Circuits
”
• “Creating Backup Circuits
,” on page 1-25
• “Creating Bandwidth Circuits,” on page 1-28
When you create a PPP dial-up circuit, Site Manager creates a special PPP record
for the circuit, which identifies who is calling the router. This record is listed in
the PPP Interface Lists window as follows:
Interface for Dialup Lines
For more information about PPP, refer to Configuring PPP Services.
Creating Demand Circuits
To configure Frame Relay demand circuits, skip this section and go to Chapter 9.
To configure PPP demand circuits:
1. Begin at the Configuration Manager window (refer to Figure 1-1).
2. Select Dialup > Demand Circuits.
Site Manager displays the Demand Pools window, listing the new pools
(Figure
1-16).
Figure 1-16. Demand Pools Window Listing Configured Pools
Comentarios a estos manuales