
Configuration Examples
117353-A Rev. A B-13
4.
From the Configuration Manager window, click on a COM connector.
5. Follow the path to the configuration windows and set the parameters
according to Tables B-
18 through B-22.
Configuration of Router 2
To configure Router 2:
1. Configure a leased, synchronous interface named S331.
2. Select PPP as the WAN protocol.
3. Select IP/RIP as the LAN protocol and configure the interface as follows:
• IP Address: 129.122.3.2
• IP Adjacent Host Address: 129.122.3.1
4. From the Configuration Manager window, click on a COM connector.
5. Follow the path to the configuration windows and set the parameters
according to Tables B-
18 through B-22.
Backup Pool Configuration
First, configure the backup pools.
Path: Dialup > Backup Pools
After you enter a backup pool ID, the Backup Lines Definition window appears.
Click on a COM connector. Site Manager displays the WAN Serial Interface Type
window, where you determine whether you want to use Sync or Async
communication. Sync is the default, so no changes are needed.
Note: These tables list only the parameter defaults you must change.
Table B-18. Backup Pools Parameter
Parameter
Router 1
(S11)
Router 2
(S331)
Pool ID 1 1
Comentarios a estos manuales