
Customizing Backup Circuits
117353-A Rev. A 10-17
5.
You can revise the schedule by changing the parameters values and
clicking on Apply.
Refer to Appendix
A for parameter descriptions.
6. Click on Done.
Removing PPP or Frame Relay Backup Service
To remove backup service:
1. Select Dialup > Backup Circuits > PPP or Frame Relay.
Site Manager displays the Primary Circuit Definition window (refer to
Figure 10-3) or the FR Primary Interface Definition window (refer to
Figure 10-4).
2. Click on either Cct Type or Intf. Type.
Site Manager displays the Circuit Options window (refer to Figure
10-2) or
the FR Interface window (refer to Figure
10-5).
3. Modify one of the following parameters:
• For PPP, change the Circuit Type parameter to Normal.
• For Frame Relay, change the Interface Type parameter to Normal.
Site Manager asks you to confirm the change, then removes the backup
circuit, and treats the leased circuit as a regular circuit.
4. Click on OK.
5. Click on Done.
Site Manager: Circuit Type parameter: page A-57
Site Manager: Interface Type parameter: page A-59
Comentarios a estos manuales