
50 Chapter 2 Configuring Companion handsets
P0609345 01
5 Receive a call.
Note: If the portable has the same DN as a desk telephone, ensure that the desk telephones is
idle and Call Forward is deactivated. Ensure that the ringer on the handset is turned on.
• On another telephone in the system, dial the telephone of the registered portable. If the
portable rings, registration is confirmed.
• If the portable does not ring or you do not hear dial tone on the portable, refer to the
Companion handset user guide for troubleshooting tips or contact system technical
support.
Registering the C3050 handset
1 Ensure that registration is enabled. Refer to “Enabling Companion handset registration” on
page 46.
2 Open the handset flap.
The portable displays the current system name or No system selected for two seconds.
3 Press the key labeled System.
The display shows WIRELESS SYSTEMS.
Note: This handset can be registered for a maximum of nine systems.
4 Press ADD to establish a radio link.
Note: If ADD does not display, start over at step 1.
The display briefly shows Adding SYSTEM:#<next available system number>.
• If the display shows No connection, the radio link was not established.
Note: If more than 30 minutes has elapsed since the last handset registration, you may
need to re-enable the system for registration. Close the flap and return to step 2.
• If a radio link is established, the display shows Pswd:.
5 Enter the registration password.
The display shows DN:
Note: If you enter the wrong password, the display shows Invld Pswd. In this case, close
the flap and repeat from step 2.
6 Enter the DN record number you want to assign to this handset.
The display shows Enter name.
• If the display shows Invld DN, then you entered an invalid DN.
• If the display shows Reg failed, the handset failed to register to the system.
• If you try to register a handset to the same system more than one, the display shows the
registered name (Registered as <name>).
Comentarios a estos manuales