Avaya COMPANION Guía de configuración descargar pdf (Pagina 18)

18 Chapter 1 Installing the Companion system

P0609345 01

b Remove the cover by lifting it up. Refer to the following figure.

Figure 4 Opening the RPI cover

3 Hang the RPI on the two screws and tighten the screws.

4 Install the remaining two screws.

5 Feed the power cord through the bottom of the RPI.

6 Route it through the clip and around the strain relief support. The following figure

shows how to route the power cord.

Figure 5 RPI components

7 Route the power cord to the input power socket just to the left of PSU 1, on the left.

8 Connect the plug to the socket.

9 Follow the appropriate wiring instructions in the wiring charts in the next section,

“Wiring the base station and connecting the RPI”.

PSU 1 PSU 2

(if equipped)

Up to 16 outputs

(TCM + power)

Up to

inputs

(TCM)

Connection board

Jumper lead to PSU 2

Power cord

Grounding strap

Power supply cabling

Strain relief support

Clip

Grounding plates

Ferrite rings

The RPI-8 has grounding straps and

plates fitted to allow an upgrade to

an RPI-16.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 65 66

Sin comentarios

Avaya COMPANION Guía de configuración Pagina 18