Avaya COMPANION Guía de configuración descargar pdf (Pagina 16)

16 Chapter 1 Installing the Companion system

P0609345 01

Remote power interconnect (RPI) unit overview

The remote power interconnect unit (RPI) provides remote power for base station support.

The following figure shows a diagram of the RPI.

Figure 2 RPI unit

There are two versions of the RPI unit:

• The RPI-8 BIX UL supports a maximum of eight base stations.

• The RPI-16 BIX UL supports a maximum of 16 base stations.

Each RPI has a connection printed-circuit board and either one (RPI-8 BIX UL) or two (RPI-16

BIX UL) power supply units (PSUs). The maximum input power consumption of an RPI is 240 W.

If you use a UPS 48 V dc backup source, the maximum input power requirement of the RPI is

140 W.

You can upgrade an RPI-8 BIX UL to an RPI-16 BIX UL by installing a second PSU to the RPI-8

BIX UL.

Caution: The RPI unit must have the DC backup power supplied by a UL listed universal

power supply (UPS).

The UPS must have an output voltage rating of 44 to 52 V DC, with a maximum fault

current limit of 6 A to protect the RPI output wiring. If these requirements are not met, it is

necessary to use class 1 wiring.

Warning: You must install the RPI units inside a building.

The AC outlet powering the RPI must be installed near the equipment and must be easily

accessible.

The length of the RPI cord, from the outside surface of the unit to the plug, must be a

minimum of 1.3 m (4.5 ft) and a maximum of 4.6 m (15 ft).

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 65 66

Sin comentarios

Avaya COMPANION Guía de configuración Pagina 16