Avaya COMPANION Guía de configuración descargar pdf (Pagina 27)

Chapter 1 Installing the Companion system 27

Business Communications Manager Companion Configuration Guide

Attaching a Companion base station

Install base stations on a wall or on a ceiling. When installing base stations on a wall, install them

with their covers at the bottom, as shown in the figure below. Allow for clearances around the base

station as indicated in the following table.

Installing the base station

1 Fasten the bracket into position using two #8 38-mm (1-1/2 in.) screws.

2 Route the cable from the BCM1000 through the top or bottom opening.

3 Wind any excess cable around the posts, then fasten the cable under the strain relief.

4 Connect the wires to the BIX connector on the bracket termination board as shown in

the following figure.

Figure 9 Bracket termination board

The polarity of the TCM connections is not important. If you connect the two power pairs to

the bracket terminal board of the base station, you must connect the power pairs with the same

polarity.

CAUTION: Ensure that the RPI is off before connecting power pairs to the base station.

5 Install the base station on the bracket. Snap it into position.

6 Connect the power RJ-11 jumper lead to the RJ-11 jacks on the termination board and

the base station.

Table 7 Clearance for the base stations

Clearance conditions Canada USA

Clearance from all other objects

9 cm 3.5 in.

Vertical clearance from base station center to base station center

27 cm 54 in.

Horizontal clearance from base station center to base station center 41 cm 54 in.

-PWR(1)

TCM

+PWR(1)

+PWR(2)

-PWR(2)

TCM

RJ11 jack

TCM

RJ11 jack

TCM

-PWR(1)

-PWR(2)

+PWR(1)

+PWR(2)

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 65 66

Sin comentarios

Avaya COMPANION Guía de configuración Pagina 27