
Configuring Data Compression Services
1-8
117352-B Rev. 00
Configuring Compression for the Access Stack Node (ASN)
To configure hardware compression for the ASN,
begin at the Configuration
Manager window and complete the tasks in the following table:
Site Manager Procedure
You do this System responds
1. Click on an empty slot and choose one of
the following net modules for hardware
compression:
• AG2104007
•
AF2104012
*
* If you have a hardware compression net module on an ASN, you can use hardware compression on
any WAN port on that single router or slot. Hardware compression on the ASN does not work
across slots; that is, it does not provide compression for any other ASNs in the stack.
Site Manager selects the net module.
2. Click on
OK
. You return to the Configuration Manager
window. The net module is added to the
slot.
3. Click on same slot that contains the
hardware compression module and
choose a WAN net module.
Site Manager selects the WAN net
module.
4. Click on
OK
. You return to the Configuration Manager
window. The WAN net module is placed
over the compression module.
5. Choose a port. The Add Circuit window opens.
6. Accept the default circuit name or enter a
new name then click on
OK
.
The WAN Protocols window opens.
7. Choose one of the following WAN
protocols:
• PPP
•
Frame Relay
Site Manager selects the protocol.
8. Click on
OK
. The Select Protocols window opens.
9. Scroll through the Select Protocols
window and choose
WCP
.
Site Manager enables compression on
this interface.
10. Click on
OK
. You return to the Configuration Manager
window.
Comentarios a estos manuales