
Using Technician Interface Scripts
2-666
303560-A Rev 00
dsucsu_config
Displays configuration information about a DSU/CSU module installed in a BayStack
AN, ANH, or ARN router. The display includes the following information:
Sample Display - show sync dsucsu_config
Configuration of DSU/CSU in Slot 1 Connector 2:
HW Revision 3
SW Revision 3
Opmode: 56K DDS1
Transmit Clock: slave (network)
Transmit Monitor (64K only): disabled
1 entry(s) found
Hardware Revision Hardware revision of the DSU/CSU module.
Software Revision Firmware revision of the DSU/CSU module.
Opmode Type of Telco service: 56K DDS1 or CC 64K.
Transmit Clock Whether this DSU/CSU receives timing from the Telco source (Slave) or
provides transmit timing in a private-wire configuration (Master).
Transmit Monitor
(64K only)
Whether the 64K Transmit Monitor is enabled. The Transmit Monitor
suppresses data to prevent unintended duplication of network control codes.
Comentarios a estos manuales