
Configuring TMS and Security for erpcd Networks
308606-14.00 Rev 00
5-3
The syntax of the command that creates a TMS entry is:
tms_dbm add
<domain> <dnis>
te=
<ip_addr_of_the_gateway>
\
maxu=
<maximum_count_of_users>
[hwtype=
<fr_or_ppp>
\
[hwaddr=
<hardware_link_address_from_home_agent_to_CPE>
\
hwalen=
<length_of_hardware_link_address>
]]\
[srvloc=servers_location] [tutype=tunnel_type]\
pauth=
<ip_addr_of_primary_authentication_server>
\
sauth=
<ip_addr_of_secondary_authentication_server>
\
[pacct=
<ip_addr_of_primary_accounting_server>
\
[sacct=
<ip_addr_of_secondary_accounting_server>
]]\
[paddr=
<ip_addr_of_primary_dynamic_address_server>
\
[saddr=
<ip_addr_of_secondary_dynamic_address_server>
]]\
authp=
<radius_or_acp>
[acctp=accounting protocol] \
[addrp=dynamic address allocation protocol]\
[spi=
<security_protocol_index>
] [passw=
<password>
] [tatype=kmd5-128\
tamode=pref-suff takey=
<authentication_key_value(hex, 256_bits)>
]
The dialed number parameter dnis is available only for the Model 8000/5399
products. By default,
dnis is set to 0 for all Remote Access Concentrators.
The
hwalen parameter is no longer required. It is included here for compatibility
with previous versions. Now, tms_dbm derives the length from the value of the
hwaddr parameter. If, for the hwaddr parameter, you specify a decimal value that
is smaller than 4 bytes (that is, from 0 through 2
31
), TMS converts that value to
hexadecimal. To specify a hexadecimal value, prefix the number with the
characters 0x; for example, to express 64 (decimal), specify 0x40. For PPP, omit
the
hwaddr parameter.
Table 5-1
lists the tunnel management (tms_dbm) commands, and Table 5-2 lists
the arguments for each of the TMS command elements.
Note:
In this syntax description, brackets [ ] indicate optional parameters.
Note:
The ha (home agent) parameter used in previous versions is still
recognized, but the
te (tunnel end point) parameter required in the current
version has taken over its function.
Comentarios a estos manuales