Avaya Bay Dial VPN Networks Manual de usuario Pagina 105

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 206
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 104
Configuring the TMS Using RADIUS
308606-14.00 Rev 00
6-11
Annex-Secondary-Srv-Endpoint
(Nortel Networks VSA 79)
Allows an ordered list of up to 10 secondary gateway
addresses to be configured. Only two of these
gateways will be attempted in case of gateway
connection failures.
Additional fields are:
Annex-Tunnel-Source-Addr (required)
Annex-Tunnel-RIP-Timeout
Annex-Tunnel-RIP-Limit
They must appear in this order. If you specify
Annex-Tunnel-RIP-Limit, you must also specify
Annex-Tunnel-RIP-Timeout.
The required Annex-Tunnel-Source-Addr field specifies
the source IP address to be used in route injection
updates. It should correspond to the addressing
scheme in use on the CPE router (that is, it should be
in the same subnet as the link from the CPE to the
gateway). If you do not specify a source address, the
gateway does not send RIP packets.
The Annex-Tunnel-RIP-Timeout field specifies the
interval, in seconds, between route injection updates
from the gateway to the CPE router when alternative
servers are used. The value is an integer from 0 to 254.
Setting the value to 0 causes the interval to default to
30 seconds.
The Annex-Tunnel-RIP-Limit field specifies an optional
limit on the number of times a route update is sent
during the lifetime of a tunnel. The value is an integer
from 0 to 254. The default is 0, which enables standard
RIP behavior (unlimited updates).
Annex-Gateway-Selection-
Mode (Nortel Networks VSA 80)
Selects a gateway in backup or load distribution mode,
or in neither mode. Values are normal (0), backup (1),
or distribution (2). If this attribute is not present, the
default mode is normal (neither backup nor load
distribution).
Table 6-5. BSAC TMS Attributes for Secondary Gateways
(continued)
Attribute Description
Vista de pagina 104
1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 205 206

Comentarios a estos manuales

Sin comentarios