Avaya RMON2 Manual de usuario descargar pdf (Pagina 90)

Configuring RMON and RMON2

C-6

300018-A Rev. 00

Enter the following Technician Interface command to download the new

software image from the router flash memory card to the DCM flash

memory:

[1:1]$ dcmload

The Technician Interface displays information about the dcmload script and

displays the following prompt:

Do you want to download an image to the Base Module DCM

or the Expansion Module DCM (b/e) [b]

If the DCM is installed on the base module, press Return. If the DCM is

installed on an ARN expansion module, enter

The Technician Interface displays the following prompt:

Specify DCM image name (volume:filename):

Enter the image name in the form

<volume:filename>.

volume

is 1 and

filename

is the name you gave the DCM image during

the file transfer.

For example, enter:

1: in_2.00.obj or 1:dcm200image.

The Technician Interface displays the following prompt:

Do you want DCM to save this image on its FLASH? (y/n) [y]

Answer yes by pressing Return.

If you answer no, the DCM uses the downloaded image only once, reverting

to the previous image at the next boot. The Technician Interface displays the

following prompt:

Do you want to start the download process? (y/n)[y]

Answer yes to begin downloading the new image, overwriting the existing

DCM software image.

The downloading process takes less than 1 minute.

Verify that the DCM software image is now Version 2.00.

See step 3 in the previous section, “Verifying Minimum DCM Requirements

”

on page C-2.

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 96

Sin comentarios

Avaya RMON2 Manual de usuario Pagina 90