Avaya RMON2 Manual de usuario descargar pdf (Pagina 44)

Configuring RMON and RMON2

3-2

300018-A Rev. 00

Configuration Considerations

If you choose, you can upgrade an ARN 100 router to collect complete RMON

and RMON2 statistics by installing an Ethernet expansion module on the router’s

base module and attaching the Ethernet DCM to it. You can collect full

RMON/RMON2 statistics only from the segment attached to the router’s Ethernet

expansion module.

You cannot collect RMON statistics from both the base module and the Ethernet

DCM (full RMON/RMON2). This restriction is enforced in the following way for

ARN 100 routers:

• If you enable the DCMMW subsystem on an ARN 100 router and then

configure mini-RMON on the ARN 100 base module, the DCMMW

subsystem is disabled. (DCMMW is unloaded and its load mask is cleared.)

• If you enable mini-RMON on the base module and you then configure the

DCMMW subsystem, mini-RMON is disabled. (Mini-RMON is unloaded

and its load mask is cleared.)

For information about installing an Ethernet DCM on an Ethernet expansion

module in an ARN router, see Installing an Ethernet RMON DCM in a BayStack

ARN Router. For information about starting RMON and RMON2 on an ARN 100

router with an installed Ethernet DCM, see Chapter 2, “Starting RMON and

RMON2 on AN/ANH and ARN Routers.”

Starting Mini-RMON

To start RMON data collection on an ARN 100 base module, use Site Manager to

perform the following tasks:

• Prepare a configuration file.

• Enable the base module and RMON data collection.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 95 96

Sin comentarios

Avaya RMON2 Manual de usuario Pagina 44