
Starting RADIUS
116752 Rev. A
1-5
3.
Select Authentication, Accounting, or Both to enable both services.
If the router is already using a slot for dial-on-demand, dial backup, or
bandwidth-on-demand service, you cannot select this slot for authentication.
This restriction does not apply to accounting.
4.
For RADIUS authentication, select the connectors that you want to serve
as RADIUS interfaces. This is not required for RADIUS accounting.
• To configure a modem line for RADIUS, click on a COM connector.
(To configure an ISDN line for RADIUS, go to pa
ge 1-7.)
Site Manager displays the Choose WAN Serial Interface Type window
(F
igure 1-4).
Figure 1-4. Choose WAN Serial Interface Type Window
On the Backbone Link Node (BLN
®
) and Backbone Concentrator Node
(BCN
®
), the Choose WAN Serial Interface Type window appears only for
ports on an Octal Sync Link Module. For all other modules, Site Manager
displays the Sync Line Media Type window (F
igure 1-5).
If you are using synchronous PPP for your dial connections, accept the
default, Sync, for the WAN Serial Interface Type parameter. Site Manager
displays the Sync Line Media Type window (F
igure 1-5). If you plan to
use Asynchronous PPP for your dial connections, select Async. Site
Manager displays the Async Line Media Type window (F
igure 1-6).
Comentarios a estos manuales