
Configuring ATM DXI Services
3-2 117375-A Rev. A
The multipath feature lets you group two or more PVCs to ensure that information
makes it across the network. When setting PVCs for multipath mode, keep the
following in mind:
• The PVCs must have the same VCI and VPI numbers.
• You can only set direct access PVCs to operate in multipath mode.
To set PVCs to use multipath mode:
1. From the Configuration Manager window, select Protocols > ATM DXI >
Interfaces.
The ATM DXI Interface List window opens.
2. Click on PVCs.
The ATM DXI PVC List window opens.
3. Select the first PVC you want to run in multipath mode.
4. Click on Multipath.
The Multipath Selection window opens. This window shows all PVCs that
you can set for multipath mode, along with the PVC you selected.
5. Select a PVC that you want to group with the first PVC.
6. Click on Select.
The ATM DXI PVC List window opens.
7. Repeat this procedure until you select all of the PVCs that you want to
run in multipath mode.
Comentarios a estos manuales