Avaya CallPilot Message Networking Manual de usuario descargar pdf (Pagina 20)

20 Chapter 2 Setting up Digital Networking

NN40090-301NN40090-301

To configure DNS on CallPilot 100/150

1 Start CallPilot Manager.

2 Click the Configuration heading.

3 Click the Unit Address/Identification link.

The Unit Address and Identification page appears.

4 In the Host name or IP Address box enter your CallPilot’s Host name.

It must be a Fully Qualified Domain Name (FQDN.)

5 In the Primary DNS box enter the IP address of the external DNS server.

6 In the Secondary DNS box enter the IP address of secondary DNS server if you use one.

7 Click Submit.

8 You must reboot CallPilot for the new settings to take effect.

To create and install hosts files on CallPilot 100/150

1 In a text editor such as Notepad, create a hosts file that contains the IP address and the hosts

name/FQDN of your CallPilot and the other CallPilot sites on your system. Make sure that the

name of your local CallPilot system comes first in the list. List the addresses in the form IP

address followed by the name/FQDN of the units, and type a line break by pressing the

Warning: The FQDN must be in the same subnet that is specified by the Subnet

Mask and the Default Gateway IP address. If you enter an FQDN that is not in the

same subnet, you can cause the CallPilot to continuously reboot. To correct this

problem, use the serial interface to change the IP address of the CallPilot. For more

information, see “Changing the IP address using a serial cable” in the CallPilot

Installation and Maintenance Guide.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 79 80

Sin comentarios

Avaya CallPilot Message Networking Manual de usuario Pagina 20