Avaya CallPilot Message Networking Manual de usuario descargar pdf (Pagina 19)

Chapter 2 Setting up Digital Networking 19

CallPilot Message Networking Set Up and Operation Guide

To check that BCM is not configured to use DNS

1 Start Element Manager.

2 On the Configuration tab, choose the Data Services folder.

The system tasks appear.

3 Choose the DNS task.

The Domain Name Service tab appears.

4 Ensure that the Enable DNS box is not selected.

5 Ensure that the Primary (& Sec.) Server IP Addr field is empty. If it is not, delete any

entries.

To check that a Host Name is entered on the BCM

1 Start Element Manager.

2 On the Configuration tab, choose the System folder.

The system tasks appear.

3 Choose the Identification task.

The System Identification tab appears.

4 Enter a system name in the System Name box, if one is not entered.

A system name can be any name (for example, myCompany).

To configure CallPilot 100/150 to use domain names or IP

addresses

If you do not have a DNS you can configure your CallPilot host to recognize the domain names of

other CallPilot sites on your system. For example, a bank can create domain names for each branch

that has a CallPilot site on their system, with the names “Downtown”, “South Side” and “West

End”, so that an employee who wants to send a message to another branch can just use its domain

name, and does not have to know the IP addresses of the branch.

1 Start CallPilot Manager.

2 Click the Configuration heading.

3 Click the Unit Address/Identification link.

The Unit Address and Identification page appears.

4 In the Host name or IP Address box enter your IP address.

5 Leave the Primary DNS and Secondary DNS boxes empty.

6 Click Submit.

7 You must reboot CallPilot for the new settings to take effect.

Note: Ensure the BCM is using a static IP address and DHCP is disabled.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 79 80

Sin comentarios

Avaya CallPilot Message Networking Manual de usuario Pagina 19