Avaya Configuring BayStack Remote Access Manual de usuario Pagina 105

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 138
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 104
Troubleshooting Network Boot Problems
117341-B Rev. 00
B-11
The following sample response shows the default settings for an AN/ANH with
one Ethernet interface and two synchronous interfaces:
Boot Options
boot image=local
boot config=network
Netboot Parameters:
XCVR1..None
COM1...EZ-Install
COM2...EZ-Install
The following sample response shows the settings for an ARN with one Ethernet
interface, one token ring interface, and five synchronous interfaces:
Boot Options
boot image=local
boot config=network
Netboot Parameters:
MAU1...None
XCVR2..None
COM1...EZ-Install
COM2...EZ-Install
COM3...EZ-Install
COM4...EZ-Install
COM5...EZ-Install
The possible settings for
boot image
and
boot config
are
network
and
local
. If the setting is
network
, the BayStack router requests the kernel file or
configuration file from a BootP server when booting. If the setting is
local
, the
BayStack router uses the kernel file or configuration file stored in flash memory.
The
XCVR parameter shows the current setting of the Ethernet connectors. The COM
parameters show the current settings of the synchronous connectors. The
MAU
parameter shows the setting of the token ring connectors (ARN only).
Vista de pagina 104
1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 137 138

Comentarios a estos manuales

Sin comentarios