Avaya Configuring RADIUS Manual de usuario descargar pdf (Pagina 111)

Configuring RADIUS with SecurID

308640-15.1 Rev 00

E-9

The authentication procedure and interface dialog that you encounter when

attempting to log in to a RADIUS client may vary depending on your particular

circumstances. Some of these circumstances are described below, but the interface

dialog is not shown. For information about the interface dialog for logging in, see

the ACE/Server documentation.

Logging In the First Time Using “New PIN” Mode

If you are logging in for the first time and you do not have a valid SecurID PIN,

you will be entered into “New PIN” mode, where the RADIUS client prompts you

through a routine for PIN assignment. (The SecurID administrator for your

network must first configure the ID system to allow you to access the PIN

assignment feature.) The SecurID administrator can enable you either to select

your own PIN, or to accept a system-generated PIN.

This sample session shows the dialogue that takes place in “New PIN” mode.

$ telnet 192.32.16.67

Password:

ARE YOU PREPARED TO HAVE THE SYSTEM GENERATE YOUR PIN? (y/n):

Your new PIN is d4ej.

Wait for the tokencode to change, then enter a new PASSCODE

Mounting new volume...

Device label:

Directory: 1:

New Present Working Directory: 1:

Welcome to the Backbone Technician Interface

[1:TN]$

1 2 ... 106 107 108 109 110 111 112 113 114 115 116

Sin comentarios

Avaya Configuring RADIUS Manual de usuario Pagina 111