
Chapter 4 VoIP Trunk Configuration 57
IP Telephony Configuration Guide
Putting VoIP lines into a line pool
Lines 001 to 060 are reserved for VoIP trunks. However, they can be used only if you have entered
the appropriate keycodes to activate them.
When putting VoIP trunks into a line pool, choose a line pool that is not used for any other type of
line.
To put your lines into a line pool:
1 In Unified Manager, open Services, Telephony Services, Lines, VoIP lines, Line 001, and
click on Trunk/Line Data. The Trunk/Line Data screen appears.
Figure 21 Trunk/Line data
2 In the Line type field, set a line pool that is not used by any non-VoIP lines.
Repeat this procedure for as many trunk lines as you have keycodes for. You can use the same line
pool for all VoIP lines.
Comentarios a estos manuales