
Remote Access
18 NN40011-032 Issue 1.2 BCM Rls 6.0
1-10 The number of attempts made by the BCM to dial-out to the
remote end during callback. Default: 3
Callback retry
interval(s)
0-360 Interval for successive connection attempts for dial-out during
callback.
Default: 60 seconds
Idle time after which, PPP will terminate the PPP connection.
Default: 1800 seconds
128-16384 The maximum size of the packets that can be received.
Default: 500
Maximum
Transmission
Unit
128-16384 The maximum size of the packets that can be sent.
Default: 500
Supported PPP authentication: PAP, CHAP, MSCHAP, MSCHAPv2.
Default: CHAP.
Line number monitored by the modem for incoming calls. Default:
blank. A value of 0 = blank. Range: Min Target Line-Max Target Line
Analog modem uses this Calling Number (Calling ID - CLID) to
detect an incoming data call.
Number of rings after which the modem picks up an incoming call.
Default: 1
Auto-disable the dial-in for modem after use.
Default: disabled
Time after which the Dial-in for the modem is disabled after use.
Default: 0 ( 0-30 Minutes)
Read-only number assigned to the analog modem. Used for manual
transfer of call or by auto-attendant.
Local IP Address Specification
If selected, the BCM obtains its IP address from the remote end.
Default: disabled.
Use this IP Address as the local IP address for the PPP connection.
This value is used when "Remote assigned" is disabled.
Comentarios a estos manuales