Avaya Configuring Data Compression Services Manual de usuario Pagina 22

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 74
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 21
Configuring Data Compression Services
1-4
117352-C Rev. 00
The type of data compression you configure depends on the upper layer protocol
you want to run over the link, as follow:
To run frame relay, use WCP.
To run PPP, use WCP if you are connecting Bay Networks routers.
Use Hi/fn LZS if you are connecting routers of different vendors.
Previous Hardware-Based Data Compression
You can continue to use hardware-based data compression services provided by
releases earlier than BayRS Version 12.20, which were based on:
Optional daughterboards for PPP and frame relay networks that use the octal
synchronous link module for the BN, using FRE-2 processors only.
Optional net modules for PPP and frame relay networks that use the ASN.
Hardware compression can compress data transmitted over WANs attached to
the following net modules: dual and quad synchronous, MCE1/ISDN PRI,
MCT1/ISDN, dual synchronous with ISDN BRI, and Quad BRI.
Note:
If a FRE-2-060E is present in the same slot as an octal synchronous
hardware compression daughterboard, the FRE-2-060E will be used instead of
the octal synchronous daughterboard.
Vista de pagina 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 73 74

Comentarios a estos manuales

Sin comentarios