Avaya Using Technician Interface Software Manual de usuario Pagina 333

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 366
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 332
Using Syslog Messaging to Monitor Router
114088 Rev. A C-25
b.
Re-enable an entity filter by entering the following command line:
$: set wfSyslogEntFltrEntry.wfSyslogEntFltrDisable.
<wfSyslogEntFltrHostIndex>.<wfSyslogEntFltrNum>.
<wfSyslogEntFltrIndex>
1;commit
Re-enabling a filter
Transitions the operational state of that filter
(wfSyslogHostOperState) to ACTIVE
Allows Syslog to resume forwarding event messages through that
filter
Deleting Remote Hosts or Entity Filters from the Syslog Configuration
You can delete a remote host from the Syslog host table, or delete a filter from the
Syslog filter table, as follows:
1. If you want to delete a remote host entry from the Syslog host table, enter
the following command line:
$: set wfSyslogHostEntry.wfSyslogHostDelete.
<wfSyslogHostDest>
2;commit
2.
If you want to delete a filter from the Syslog Entity Filter table, enter the
following command line:
$: set
wfSyslogEntFltrEntry.wfSyslogEntFltrDelete.
<wfSyslogEntFltrHostIndex>.
<wfSyslogEntFltrNum>.<wfSyslogEntFltrIndex>
2;commit
3.
Save the changes to your configuration. (Refer to Task 8, earlier in this
appendix.)
Deleting Syslog from the Router
If you want to delete Syslog from the router, change the setting for
wfSyslogDelete, a global parameter/attribute, as follows:
$:set wfSyslog.wfSyslogDelete.0 2;commit
Vista de pagina 332
1 2 ... 328 329 330 331 332 333 334 335 336 337 338 ... 365 366

Comentarios a estos manuales

Sin comentarios