Avaya Using Technician Interface Software Manual de usuario Pagina 241

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 366
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 240
System Administration
114088 Rev. A 8-77
You can determine the circuit number from the router’s active MIB by using the
Technician Interface
get command in a variety of ways.
Example:
The following command retrieves the circuit number (attribute 6) for every entry
in the FDDI Line_Table:
$ g wfFddiEntry.6.*
wfFddiEntry.wfFDDICct.5.1 = 1
(The table has a single line entry.)
Example:
The following command retrieves the circuit number (attribute 6) for every entry
in the CSMACD Line_Table:
$ g wfCSMACDEntry.6.*
wfCSMACDEntry.wfCSMACDCct.2.1 = 3
wfCSMACDEntry.wfCSMACDCct.2.3 = 2
Example:
The following command retrieves the circuit number (attribute 5) for every entry
in the IP Interface table:
$ g wfIpInterfaceEntry.5.*
wfIpInterfaceEntry.wfIpInterfaceCircuit.192.32.174.33.3 = 3
wfIpInterfaceEntry.wfIpInterfaceCircuit.192.32.174.66.4 = 4
wfIpInterfaceEntry.wfIpInterfaceCircuit.192.32.174.98.2 = 2
wfIpInterfaceEntry.wfIpInterfaceCircuit.192.32.175.66.1 = 1
The instance ID for each entry in this case is <IP_address.circuit_number>:
Vista de pagina 240
1 2 ... 236 237 238 239 240 241 242 243 244 245 246 ... 365 366

Comentarios a estos manuales

Sin comentarios