
Using Technician Interface Software
7-8 114088 Rev. A
Examples:
Committing MIB Sets
The commit command causes all previously entered set commands to take effect.
When you enter
commit, the system notifies all software services whose
configuration parameters have changed.
Refer to the following section to copy all MIB values from operating RAM to a
configuration file for later retrieval.
If you enter: The system:
Any one of the following:
set wfSnmp.wfSnmpDisable.0 1
set 1.3.6.1.4.1.18.3.5.3.5.1.1.0 1
set wfSnmp.1.0 1
Changes the value of wfSnmp.wfSnmpDisable.0
(1.3.6.1.4.1.18.3.5.3.5.1.1.0) to 1 to enable SNMP.
set
wfIpInterfaceEntry.2.192.32.13.99.32
Changes the value of wfIpInterfaceEntry.WfIpInter-
faceEnable.192.32.13.99 to 2. This disables IP for
the interface whose IP address is 192.32.13.99 and
whose circuit is 3.
Both of the following:
set wfBrTp.2.0 1
set wfBrStp.2.0 1
Changes the values wfBrTp.wfBrTpBaseEnable.0
and wfBrStp.wfBrStpBaseEnable.0 to 1 to enable
the Translating Bridge and Spanning Tree.
Both of the following:
set wfBrTp.2.0 2
set wfBrStp.2.0 2
Disables the Translating Bridge and Spanning Tree.
Comentarios a estos manuales