Avaya Configuring Remote Access Manual de usuario Pagina 131

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 186
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 130
Configuring a Data Collection Module
114084 Rev. A 7-21
HostTopN Group
To save memory and increase performance, there is no default configuration for
the HostTopN group. You must create HostTopN configurations through your
RMON network management application. You can create as many HostTopN
configurations as memory permits, up to the RMON limit of 65,535
configurations.
Each HostTopN configuration requires 164 bytes. The HostTopN data requires 10
bytes of memory per host address that the DCM detects on a segment.
You calculate the total memory (in bytes) that you need for the HostTopN data as
follows:
10 * Value for the RMON Max Host parameter
Refer to the previous section for information on setting the RMON Max Host
parameter.
Matrix Group
When you enable the DCM, the default setting (Disable) for the RMON Default
Matrix parameter prevents the DCM from setting up a Matrix configuration. To
create a Matrix configuration, set the RMON Default Matrix parameter to Enable
before you enable the DCM as described in the “Acti
vating the DCM” section.
Some RMON network management applications expect the DCM to set up a
Matrix configuration, while others set up their own configurations.
The Matrix configuration requires 212 bytes. The Matrix data requires
approximately 178 bytes of memory per source/destination pair that the DCM
detects on a segment.
Note: Before you create a HostTopN configuration, you must create a Host
configuration.
Note: The RMON agent allows you to create only one Matrix configuration.
Be sure to set the RMON Default Matrix parameter according to the
expectations of the RMON network management application.
Vista de pagina 130
1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 185 186

Comentarios a estos manuales

Sin comentarios