
Configuring Remote Access
7-14 114084 Rev. A
2. Set the Enable/Disable parameter to DISABLE.
3. Click on OK.
4. Select Platform > DCM 11.0 and later > Global > Base Module DCM
again to return to the Edit Base Module DCM Parameters window.
5. Set the Configuration Mode parameter to SHARED MEMORY.
6. To use this configuration in subsequent boots, set the Save Configuration
Info parameter to WRITE.
7. Set the remaining configuration parameters (RMON Max Host, RMON
Default Host, and RMON Default Matrix) to the desired values.
For information, see “DCM Global P
arameter Descriptions,” earlier in this
chapter.
8. Set the Enable/Disable parameter to ENABLE.
9. Click on OK.
Deleting the DCM Software Subsystem
The router requires the DCMMW software to communicate with the DCM board.
Deleting DCMMW deactivates the DCM board.
To completely deactivate the DCM board:
1. From the Configuration Manager window, select Platform > DCM 11.0
and later > Delete DCM, and then select one of the following:
• Base Module DCM only - to remove the DCM software subsystem from
an AN or ANH, or from an ARN base module.
• Expansion Module DCM only - to remove the DCM software subsystem
from an ARN Ethernet expansion module.
• All DCMs - to remove the DCM software subsystem from all modules on
the current platform.
The Configuration Manager displays a confirmation prompt.
Note: Always try disabling the DCM board by setting the Enable/Disable
parameter to Disable before you delete the DCMMW software.
Comentarios a estos manuales