Avaya Configuring SNMP, RMON, BOOTP, DHCP, and RARP Services Manual de usuario Pagina 76

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 130
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 75
Configuring SNMP, RMON, BOOTP, DHCP, and RARP Services
2-18 114070 Rev. A
3. Click on OK to exit the Edit Base Module DCM Parameters window.
Booting the Ethernet DCM
To reboot an installed Ethernet DCM board, disable and then reenable the
Ethernet DCM as described in the previous sections.
Deleting the Ethernet DCM Software Subsystem
The router requires the DCMMW software to communicate with the Ethernet
DCM board. Deleting DCMMW deactivates the Ethernet DCM board.
To completely deactivate the Ethernet DCM board from the Configuration
Manager window:
1. Select Platform > DCM 11.0 and later > Delete... > Base Module DCM
only (F
igure 2-6).
Figure 2-6. Deleting DCM from the Configuration Manager Window
The Configuration Manager displays a confirmation prompt.
Note: Always try disabling the Ethernet DCM board by setting the
Enable/Disable parameter to Disable before you delete the DCMMW
software.
Vista de pagina 75
1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 129 130

Comentarios a estos manuales

Sin comentarios