
Configuring SNMP, RMON, BOOTP, DHCP, and RARP Services
1-6 114070 Rev. A
Enabling SNMP Services
You must enable IP services to use SNMP. When you enable IP services, you are
required to configure only a few parameters. The Configuration Manager supplies
default values for the remaining parameters.
This section assumes that you have read Configuring Routers or Configuring
Customer Access and Trunks (BNX Software), depending on the type of installed
software, and that you have
1. Opened a configuration file
2. Specified router hardware if this is a local-mode configuration file
3. Selected the link or net module connector on which you are enabling IP
services, or configured a WAN circuit if this connector requires one
Enabling IP on an Interface
When you select either a link or net module connector, or when you finish
configuring a WAN circuit, the Select Protocols window appears (F
igure 1-1).
Note: The window displays only those protocols that the circuit type supports.
Comentarios a estos manuales