
Configuring Routers
3-8 114080 Rev. A
To transfer files from the Site Manager workstation to a router, you must do the
following:
1. Choose the router to which you want to transfer the file.
2. Examine the existing filenames on the router destination volume.
3. Verify that adequate free space exists on the destination volume.
4. Transfer the file to the destination volume.
The following sections describe these tasks.
Choosing a Router
To choose the router to which you want to transfer the file, follow these steps from
the Router Files Manager window:
1. Select Options > Router Connection from the Router Files Manager
window.
The Router Connection Options window appears
(Figure 3-8).
Caution: The destination system in a file transfer automatically overwrites
any file already on its volume that has the same filename. If enough space does
not exist on the file system for the new file, and the new file has the same name
as an old file, the old file will be destroyed and the new file will be corrupted.
This is because TFTP copies the new file over the old and runs out of space
before completing the copy. Be sure to follow the instructions in this section to
avoid corrupting the config file.
Comentarios a estos manuales