Avaya Configuring Routers Manual de usuario Pagina 53

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 108
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 52
Adding Network Interfaces
114080 Rev. A 2-7
Figure 2-3. Select Protocols Window
The window differs slightly according to circuit type, displaying only those
protocols that the circuit type supports. In addition, for certain circuit types, the
window allows you to select the protocol priority feature (refer to Configuring
Traffic Filters and Protocol Prioritization for instructions about configuring
protocol prioritization).
To enable bridging/routing services, complete the following steps:
1. Select all bridging/routing protocols that you want to enable on the
circuit.
2. Click on OK.
If you select Spanning Tree, the Configuration Manager enables the Bridge
protocol because Spanning Tree is a Bridging service. (Note that in the Select
Protocols window, Spanning Tree is indented beneath the Bridge line.) Similarly,
if you select RIP, EGP, BGP, OSPF, BOOTP, IGMP, or DVMRP, the
Configuration Manager enables IP because these are all IP services. If you select
RIP (IPX) or RIP (XNS), IPX or XNS is enabled automatically.
Vista de pagina 52
1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 107 108

Comentarios a estos manuales

Sin comentarios