
Adding Network Interfaces
114080 Rev. A 2-3
Configuring the Circuit
To configure a circuit, begin at the Configuration Manager window, and complete
the following steps:
1. Click on the link module connector you want to connect to the network.
The Add Circuit window appears
(Figure 2-1).
Figure 2-1. Add Circuit Window
A default circuit name appears in the Circuit Name box. The default circuit
name consists of a circuit type designator
(Table 2-1) followed by two sets of
numbers that identify the circuit location (the first number is between 1 and 14
and identifies the router slot; the second number is between 1 and 8 and
identifies the specific connector in that slot).
For example, the circuit name S51 in
Figure 2-1 identifies a synchronous
circuit in Slot 5 on Communications Port 1.
Note: Refer to Configuring Line Services for instructions on adding MCT1 or
MCE1 circuits.
Comentarios a estos manuales