Avaya Configuring ATM Services Manual de usuario Pagina 67

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 426
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 66
Understanding ATM, ATM Router Redundancy, and OAM
308612-14.00 Rev 00
1-41
Creating a Network of Adjacent Hosts
You can create a network of routers that are connected by ATM WAN SVCs by
configuring IP or IPX adjacent hosts. On each router, you should configure the
following:
One WAN SVC service record for each IP subnet or IPX subnetwork
Adjacent host entries for each router in the same subnet
Each adjacent host you configure has a static mapping to an ATM address. Once
you have configured adjacent hosts, you can specify PCR and SCR settings for the
WAN SVCs to any particular adjacent host by configuring the traffic shaping
parameters.
For information about how to configure traffic shaping, see “Enabling Traffic
Parameters” on page 8-8.
Routing Updates
The way the router sends routing updates over a WAN SVC differs depending on
the number of adjacent hosts per circuit. If you have configured only one adjacent
host per circuit, Nortel Networks recommends that you set the routing mode to
dial-optimized so that the router sends routing updates only when data traffic
causes the router to establish an SVC to the adjacent host.
When you have configured multiple adjacent hosts per circuit, the router should
send routing updates periodically to ensure that all hosts in the subnet have
complete knowledge of the network topology. In this case, you should use the
normal routing mode instead of dial-optimized routing.
For more information about configuring routing updates, see “Changing the
Routing Update Policy” on page 8-5.
PVC Operations and Management Concepts
In most ATM networks, if a PVC fails, the remote device does not receive
notification of the failure at the ATM layer. Instead, the device receives this
information from a non-ATM source such as a routing protocol that operates
above the ATM layer. The PVC Operations and Management (OAM) feature
provides a mechanism by which ATM devices can receive prompt failure
information.
Vista de pagina 66
1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 425 426

Comentarios a estos manuales

Sin comentarios