Avaya Configuring Frame Relay Services Manual de usuario Pagina 61

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 94
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 60
Customizing Frame Relay
117376-A Rev. A 3-15
Using Traffic Shaping
To use traffic shaping, you configure three PVC parameters: Committed Burst,
Excess Burst, and Throughput. There is no Enable parameter as such. You may
also want to edit values for the PVC Congestion Control and Congestion Method
parameters. To enable traffic shaping, complete the tasks in the following table.
10.Click on PVCs. The FR PVC List for Service window
opens.
11.Set the following parameters, using Help
or the parameter descriptions that begin
on page A-
18:
Congestion Control
Congestion Timer
Congestion Counter
Congestion Method (applies only
when you enable traffic shaping)
12.Edit other parameters if you want, and
click on Apply.
13.Click on Done. You return to the main Configuration
Manager window.
Site Manager Procedure
You do this System responds
1. In the Configuration Manager window,
click on a port configured for frame relay.
The Edit Connector window opens.
2. Click on Edit Circuit. The Frame Relay Circuit Definition
window opens.
3. Click on Services. The Frame Relay Service List window
opens.
4. Select the appropriate service record and
click on PVCs.
The Frame Relay PVC List window
opens.
5. Click on a PVC that you want to configure
for traffic shaping.
(continued)
Site Manager Procedure
(continued)
You do this System responds
Vista de pagina 60
1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 93 94

Comentarios a estos manuales

Sin comentarios