Avaya Configuring DLSw Services Manual de usuario Pagina 87
- Pagina / 272
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Starting DLSw
304233-A Rev. 00
3-9
Starting DLSw over Frame Relay
When configuring DLSw over Frame Relay, IBM provides two types of Frame
Relay support:
• Boundary Network Node (BNN) -- RFC 1490 or Routed SNA
• Boundary Access Node (Bridged Format)
Bay Networks routers select BNN or BAN when you configure the DLSw/Frame
Relay network. When configuring a Frame Relay interface for DLSw, a message
prompts you to select either BNN or BAN.
Starting DLSw over Frame Relay BAN
BAN frames use a standard RFC 1490 Bridged 802.5 Over Frame Relay format.
Since this is a source-routed frame, you must enable SRB on this interface. When
you select BAN, SRB is automatically enabled and you must configure it.
Specifically:
• If SRB has not been previously configured on the router, the SRB Global
Parameters screen appears.
• The SRB Interface Parameters screen appears.
For more information about configuring SRB, see Configuring Bridging Services.
13. Set the following parameters:
• Link Station Address (hex)
• PU Name
•
Source (Virtual) MAC (hex
)
•
Source (Virtual) SAP (hex
)
• Destination MAC (hex)
• Destination SAP (hex)
Click on
Help
or see the parameter
descriptions beginning on page A-28.
14. Click on
OK
. DLS Local Device Configuration window
opens.
15. Click on
Done
. The Configuration Manager window
opens.
Site Manager Procedure
(continued)
You do this System responds
- Configuring 1
- DLSw Services 1
- Trademarks 2
- Restricted Rights Legend 2
- Statement of Conditions 2
- Contents 5
- 304233-A Rev. 00 10
- Before You Begin 17
- Text Conventions 18
- Acronyms 19
- Related Publications 20
- How to Get Help 22
- Chapter 1 23
- Data Link Switching Overview 23
- DLSw Networking Overview 24
- RFC 1795 Support 25
- UDP Explorer Frames 27
- RFC 2166 Multicast Support 28
- Figure 1-3. Multicast DLSw 32
- Single-Switch Services 35
- Dual-Switch Services 37
- SNA PU Descriptions 39
- LLC Support 41
- SDLC Support 41
- Primary SDLC Support 42
- Secondary SDLC Support 43
- Negotiable SDLC Support 45
- Frame Relay Support 46
- QLLC Support 48
- DLSw/APPN Boundary Function 48
- DLSw/APPN Components 50
- DLSw Router 52
- PU2.1 devices 53
- DLSw Backup Peer Support 54
- DLSw Filtering 54
- DLSw Prioritization 55
- Protocol Prioritization 55
- Chapter 2 57
- DLSw Implementation Notes 57
- DLSw and Other Subsystems 58
- Combining DLSw and SRB 58
- SRB network 59
- Virtual Rings 60
- DLSw and SRB on a Circuit 61
- DLSw and Bridging Services 62
- DLSw with Translation Bridge 63
- . Parallel 65
- Multiple DLSw Peers on a LAN 66
- Memory Requirements 66
- TCP Considerations 67
- Flow Control 67
- LLC2 Flow Control 68
- DLSw Packaging 69
- DLSw Priority Queues 71
- Nonordered Queues 73
- The Dequeue List 73
- Weighted Dequeuing Algorithm 74
- Backup Peers 77
- Chapter 3 79
- Starting DLSw 79
- Starting DLSw over Ethernet 83
- Starting DLSw over Token Ring 84
- Starting DLSw over SDLC 84
- Configuring LLC Services 90
- Deleting DLSw from a Node 92
- Chapter 4 93
- DLSw SAP Table 96
- Configuring DLSw Services 100
- (continued) 101
- (continued) 102
- DLSw Slot Table 103
- Customizing DLSw Services 105
- DLSw Peer IP Table 107
- Broadcast Peers 110
- Unconfigured Peers 111
- Configuring SDLC 115
- Services 115
- Editing a Local Device 116
- Configuring DLSw Packaging 122
- APPN Services 126
- Configuring DLSw Backup Peers 130
- Configuring Traffic 139
- Appendix A 141
- DLSw Service Parameters 141
- Caution: 143
- DLSw Basic Global Parameters 144
- 170
- 171
- 173
- 176
- Parameters 192
- VCCT Slot Parameter 199
- Adding Queue Parameters 212
- Appendix B 217
- Predefined DLSw Criteria 218
- DLSw Reference Points 218
- (bits) Length (bits) 219
- Specifying MAC Address Ranges 220
- Table B-6. SAP Codes 222
- Appendix C 223
- Troubleshooting DLSw 223
- * Enabled by default 224
- Table C-2. Log Messages 225
- Table C-3. DLSw State Table 226
- Table C-4. DLSw Event Table 227
- Sample Log Entries 228
- DLSw Session Setup 229
- Reviewing the Network Log 232
- Unexpected protocol action 242
- TCP open error 29 243
- DLSw Troubleshooting Tables 244
- IBMLAN.INI 248
- NBASE.exe 249
- SDLC.exe 249
- Verifying the WAN Cabling 251
- Flow Diagrams 253
- RFC 1795 255
- DLSw Version 2.0 256
- Version 2.0 Router) 258
- RFC 1490 264
Relacionado con productos y manuales para Redes Avaya Configuring DLSw Services
Redes Avaya Configuring DLSw Services Manual de usuario
(256 paginas)
(256 paginas)
Redes Avaya Configuring Branch Office Tunnel between a Contivity and a BayRS Router Manual de usuario
(29 paginas)
(29 paginas)
Redes Avaya Call Center Reporting Guía de usuario
(37 paginas)
(37 paginas)
Redes Avaya Quick2Config Manual de usuario
(110 paginas)
(110 paginas)
Redes Avaya BSG8/12 1.0 Guía de configuración
(200 paginas)
(200 paginas)
Redes Avaya 1150E Guía de usuario
(200 paginas)
(200 paginas)
Redes Avaya BayRS Version 15.0.0.0 aviso
(72 paginas)
(72 paginas)
Redes Avaya BCM450 Guía de configuración
(12 paginas)
(12 paginas)
Redes Avaya BayRS Version 12.10 Manual de usuario
(194 paginas)
(194 paginas)
Redes Avaya BCM 2.0 Networking Manual de usuario
(42 paginas)
(42 paginas)
(32 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.068 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales