
Configuring DLSw Services
A-26
304233-A Rev. 00
Figure A-6. DLSw Interface Configuration Window
Parameter: Enable
Path:
Configuration Manager > Protocols > DLSw > Advanced > Interfaces
Default: Enable
Options: Enable
|
Disable
Function: Enables or disables Data Link Switching over this interface.
• Enable -- Initializes the DLSw interface that you added to a physical circuit.
Also use the Enable setting to reinitialize an existing DLSw interface disabled
earlier. The state of the interface depends on the up/down state of the
associated circuit and slot.
• Disable -- Switches a DLSw interface from the enabled (up) state to the
disabled (down) state.
Instructions: Select Enable if you previously set this parameter to Disable and now want to
reenable data link switching over this interface.
Select Disable only if you want to disable data link switching over this interface.
This cancels all active LLC2 sessions currently supported by the interface.
MIB Object ID: 1.3.6.1.4.1.18.3.5.1.5.2.1.2
Comentarios a estos manuales