
Configuring DLSw Services
A-44
304233-A Rev. 00
Parameter: Transport Type
Path:
Configuration Manager > Protocols > DLSw > Peer IP Table
Default: Unknown
Options: TCP
|
UDP
|
Unknown
Function: Specifies the transport capabilities at the remote peer: TCP (Transmission
Control Protocol), UDP (User Datagram Protocol), or Unknown. The local
router attempts to use this configured transport option when establishing a TCP
connection with the remote peer. The Transport Type parameter is available only
when the DLSw RFC Version parameter is set to V2.0.
A remote peer configured with the transport type TCP operates in RFC 1795
mode. A remote peer configured with the transport type UDP operates in DLSw
Version 2.0 mode only. When set to UDP, the router does not make any attempts
to revert to RFC 1795.
An “unknown” peer operates in DLSw Version 2.0 mode. Unless a TCP
connection already exists, the local peer uses UDP explorer frames to locate the
remote peer MAC address prior to establishing the connection.
The “unknown” peer can revert to RFC 1795 if there is no response to the UDP
explorer frames.
Instructions: Click on Values and select TCP, UDP, or Unknown. If you select Unknown, use
the SNA Fallback Attempts parameter to set the number of connection attempts
using UDP explorer frames before reverting to earlier RFCs.
MIB Object ID: 1.3.6.1.4.1.18.3.5.1.5.5.1.10
Parameter: Peer Interoperability
Path:
Configuration Manager > Protocols > DLSw > Peer IP Table
Default: Enabled
Options: Enabled
|
Disabled
Function: Allows interoperability with other vendors’ routers.
Instructions: Select the default, Enabled, or choose Disabled.
MIB Object ID: 1.3.6.1.4.1.18.3.5.1.5.5.1.17
Comentarios a estos manuales