Avaya BCM Imaging Tool Guía de usuario descargar pdf (Pagina 20)

20 Loading the BCM Image

NN40010-314 01.02

Loading the BCM Image from a CD-ROM drive

To load the BCM Image from a CD-ROM drive, you must have a CD-ROM drive connected to the

Business Communications Manager system.

1 Connect the required equipment to the Business Communications Manager. For information

about how to connect the equipment, refer to “Connecting to the Business Communications

Manager” on page 13.

2 Turn on the monitor connected to the Business Communications Manager.

3 If you are using a USB CD-ROM drive, turn on the CD-ROM drive power switch.

If you are using an IDE CD-ROM drive, connect power to the Business Communications

Manager to power up the CD-ROM drive.

4 Load the BCM Imaging Tool CD into the CD-ROM drive connected to the Business

Communications Manager.

5 If you are using a USB CD-ROM drive, connect power to the Business Communications

Manager.

If you are using an IDE CD-ROM drive, reboot the Business Communications Manager by

disconnecting power from the Business Communications Manager and then reconnecting

power.

The Startup Menu appears.

Nortel Networks recommends that you load the same software version that is currently on

the Business Communications Manager system.

If you would like to change the software version, use the Business Communications

Manager Upgrade Kit after you have finished loading the BCM Image. The Upgrade Kit

includes additional updates that are not loaded when you use the BCM Imaging Tool.

For example, the Upgrade Kit for software version 3.5 includes a BIOS update that

enables USB support. If you used the BCM Imaging Tool to change the software version

from 3.01 to 3.5, the Business Communications Manager system would not get the update

required to support USB CD-ROM drives.

Tip: Loading the BCM Image from an IDE CD-ROM drive is much faster than loading

the BCM Image from a USB CD-ROM drive.

If you connected a USB CD-ROM drive to the Business Communications Manager, load

the BCM image using a shared network drive whenever possible. Loading the BCM

Image from a shared network drive significantly reduces the amount of time it takes to

load the BCM Image. (Loading from a USB CD-ROM drive takes approximately 65

minutes, while loading from a shared drive or IDE CD-ROM drive takes approximately 15

minutes.)

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 41 42

Sin comentarios

Avaya BCM Imaging Tool Guía de usuario Pagina 20