
BayRS, BCC, and Site Manager Software Version 15.1.0.0 Fixed Anomalies
308681-15.1 Rev 00
9
CR Q00062966-01: IP Accounting
When you use the Technician Interface to issue a MIB set to delete IP Accounting,
all slots on the router fault.
CR Q00065160: Passport 5430/FT1
If you configure an FT1 module on a Passport 5430 as a frame relay switch, then
physically disconnect the module from the network, the sync LED for the FT1
stays on and the state of upper-level protocols, such as IP, remains up. If you
reconnect the link and then disconnect it again, the router does not register the
event in the log.
CR Q00065163-02
If you configure an FT1 module on a Passport 5430 with PPP, and you physically
disconnect the module from the network for an extended period of time and then
reconnect, the log reports that an LCP request is being sent. However, the
show sync
stats do not show any increment in receive or transmit frames and the
upper-level protocols, such as IP, remain down.
CR Q00067170-02: ATMLANE
A router configured with VRRP and MPOA on ATM may fault when it boots.
CR Q00067980-02: DVMRP
When an upstream link fails in a redundant topology, a downstream router may
not log that it had pruned its upstream interface while receiving interim route
changes (via redundant paths). If this occurs, traffic will not be forwarded to the
downstream router until the prune timer expires.
CR Q00068488-01: DLSw
The Technician Interface command
disable dls circ
does not work.
CR Q00072116-01: Filters
A router you configure to announce the default route via a RIP announce does not
advertise the configured metric.
Comentarios a estos manuales