Avaya BayRS and BCC Software Version 15.4.0.1 Fixed Anomalies Manual de usuario descargar pdf (Pagina 6)

The BayRS router will fault if an ethernet interface is configured with ARPINARP and host cache

aging.

Q00490837: RIP

RIP1 is importing RIP2 multicast updates and installing subnetted networks in the routing table. A

new MIB parameter, wfRipIntfRipCompatible, has been added to make RIP work in conformance

with RFC 1723. This acts a control switch to determine whether to accept RIP1 only, RIP2 only or

both. It is configurable on a per interface basis. If enabled, RIP2 packets are broadcast, RIP1

ignores multicast packets and installs only natural address and mask in the routing table when it

receives a RIP2 packet.

Q00491890: BCC_DLSw

Entering ‘dlc-type sync’ on serial port in BCC causes a bus error.

Q00493592-01: PP5430

FT-1 SDB modules in a PP5430 router may fail online hardware diagnostics after the router

experiences a watchdog fault. The PP5430 Diags v1.16 needs to be loaded to resolve this issue.

Q00494478-01: VRRP

Disabling VRRP causes the router respond to ARP requests with a bogus MAC address.

Q00494662-01: Scripts

Execution of show commands on a PP5430 router results in a memory leak.

Q00494678-03: PP5430

A watchdog fault may occur on a PP5430 router when passing small frame IP traffic.

Q00494691: PP5430

The PP5430 Diags may erroneously read the FE-1 SDB as an ISDN SDB resulting in watchdog

faults or hangs on the router. The PP5430 Diags v1.16 needs to be loaded to resolve this issue.

Q00495479-01: NAT

The NAT process may fault on boot up due to a timing issue where it tries to translate before other

processes are up.

Q00499411-01: PP2430

On a PP2430 router that is configured for either Dial Backup or Hot Standby backing up an FT1

link, when the router detects a primary link failure on the FT1, the ISDN module will stop

transmitting.

Q00502090: Protocol Priority

The disabling and subsequent enabling of Protocol Priority on an interface fails to properly set the

wfCctOptsCct parameter resulting in Protocol Priority not functioning on that interface.

Q00503352: BCC_IP

When one IP interface of a multinetted IP circuit is deleted through BCC and that config file is

saved then viewed through Site Manager, the Circuit Definition window will not show any

configured protocols.

Q00510064-01: VRRP

1 2 3 4 5 6 7

Sin comentarios

Avaya BayRS and BCC Software Version 15.4.0.1 Fixed Anomalies Manual de usuario Pagina 6